ENGLISH
39
SETTING THE CH LEVEL
■Note : Depending on the speaker settings ("N (No)"), some channels cannot be selected.
• The LFE level can be adjusted within the range of -10
~ 0 dB and other channel levels within the range of -15
~ +15 dB.
• In general, we recommend the LFE level to be
adjusted to 0 dB. If the recommended levels seem
too high, lower setting as necessary.
3. Repeat the above steps 1 and 2 to adjust each
channel level.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s
memory("CAL"), not into preset memory ("REF 1", "REF 2")
• After adjusting each channel level with test tone, adjust the channel levels either according to the program
sources or to suit your tastes. (For details, refer to "Adjusting each channel level with test tone" on page 19.)
Adjusting the current channel level
Example) When selecting Dolby Digital source's LFE
2. Press the CURSOR LEFT(◀)/RIGHT(▶) buttons
to adjust the level of the selected channel or Dolby
Digital source's LFE as desired.
1. Press the CURSOR UP(▲)/DOWN(▼) buttons
to select the desired channel.
RD7405(A)100225_RD7405(A).qxp 2010-03-09 오전 9:47 페이지 39
To Next Page
Loading...
Need help?
General
