59
Settings (EW-EN100)
The setting function cannot be used while riding the bicycle.
RD protection reset
In order to protect the system from falls etc., if the bicycle is subjected to a strong impact, the “RD Protection function” is
enabled. The connection between the motor and the link will be momentarily severed so that the rear derailleur can no
longer operate.
Executing “RD Protection Reset” restores the connection between the motor and the link, as well as the function of the rear
derailleur.
1.
Hold the button down (for roughly eight seconds)
until LED1 flashes red.
Once LED1 is flashing, release the button. When only
LED1 is flashing red, the system is in the RD protection
reset mode.
LED2
LED1
Button
2.
Rotate the crankarm.
Connection of motor and the link is restored.
Adjust
You can adjust gear shifting only when using an electronic gear shifting unit.
If you need to adjust the derailleur, contact your place of purchase.
To Next Page
Loading...
