64
Code
Display
preconditions
Operational restriction when
an error is being displayed
Remedy
E025
This is displayed
when a genuine
drive unit is not
connected.
This is displayed if
any of the cables
are disconnected.
No system functions will start.
Connect a genuine battery and drive unit.
Check the condition of the cables.
E030
The installed
shifting component
differs from the
component
configured in the
system.
Assist will not be provided
when riding.
Contact your place of purchase or the distributor.
E033
The current
firmware is not
compatible with
this system.
Assist will not be provided
when riding.
Contact your place of purchase or the distributor.
E043
Part of the cycle
computer’s
firmware may be
damaged.
Assist will not be provided
when riding.
Contact your place of purchase or the distributor.
Error indications (EW-EN100)
When an error occurs, the two LEDs on EW-EN100 will quickly flash red at the same time.
If this occurs, follow one of the procedures below to reset
the indication.
•
Press the battery power switch to turn the power OFF.
•
Remove the battery from the mount.
If the situation does not improve even after turning the
power back ON, contact your place of purchase or the
distributor.
LED2
LED1
To Next Page
Loading...
