Shure AD4D - Page 29

Shure Incorporated
29/42
1.
2.
3.
4.
Network
Mode
Port Function and Signals
Application
Port 1 Port 2
Port 3 (Pri
mary)
Port 4 (Se
condary)
SWITCHED
Shurecon
trol, Dante
primary
Shurecon
trol, Dante
primary
Shurecon
trol, Dante
primary
Shure control,
Dante primary
For single network installations of star or
daisy-chained networks.
SPLIT/RE
DUNDANT
(Factory
setting)
Shurecon
trol
Shurecon
trol
Danteprima
ry
Dantesec
ondary
Primaryandsecondaryportsareconfig
uredareseparatenetworkstoprovideiso
lation between control signals and audio
signals.
To configure the switch mode:
Device Configuration > Network Configuration.
Select Setup to enter the Switch Configuration menu.
Use the control wheel to change the mode.
Press ENTER to reboot the receiver and change the mode.
Diagram of switched mode: