Shure AD4D - Saving Receiver Settings as User Presets; Programming Transmitters Using IR Presets; Encryption; Restoring the Receiver to Factory Settings

Shure Incorporated
33/42
•
•
•
1.
2.
3.
1.
2.
3.
4.
1.
2.
Saving Receiver Settings as User Presets
User presets allow a current receiver setup to be saved and restored. Presets store all receiver settings to provide a quick way
to configure a receiver or switch between several different setups. Up to 4 presets can be stored in receiver memory.
From the Device Configuration menu, navigate to User Presets and choose one of the following options:
Restore a User Preset: Use the control wheel to select a previously saved preset
Save a User Preset: Use the control wheel to save the current receiver settings as a preset
Delete a User Preset: Use the control wheel to select and delete a preset
Programming Transmitters Using IR Presets
Configuring IR presets allow all transmitter parameters to be automatically set from the receiver during an IR sync.
Individual parameters can be configured in the IR Presets menu. Each preset has the default value of No Change, which leave
that setting unchanged by an IR sync.
Select from the channel menu: IR Presets
Use the control wheel to select and edit parameters from the preset list. Select No Change to keep existing settings.
Press ENTER to save.
Encryption
The receiver features Advanced Encryption Standard (AES-256) to ensure that only the receiver that is keyed to the transmitter
can monitor the audio content.
Note: When enabled, encryption is applied to all receiver channels. Encryption does not affect Dante audio signals, audio quality, or channel spacing.
From the Device Configuration menu: Device RF > Encryption.
Use the control wheel to select On.
Press ENTER to save.
Perform an IR sync to complete the encryption between the transmitter and the receiver. The encryption key icon will
appear on the display of both the receiver and the transmitter.
Note:
Anychangetotheencryptionstatusonthereceiversuchasenabling/disablingencryptionorrequestinganewencryp
tion key, requires a sync to send the settings to the transmitter.
Tip: To remove encryption, use the control wheel to select Off and re-sync the transmitter to clear the encryption.
Restoring the Receiver to Factory Settings
The Factory Reset function clears the current settings and restores the factory settings.
Caution: All current settings will be cleared during the reset and the receiver will need to reboot.
From the Device Component menu: Factory Reset
Press ENTER to reset the receiver, or press EXIT to return to the Device Configuration menu.