Shure Incorporated
30/42
1.
2.
3.
1.
2.
3.
IP Address Configuration
An IP address must be assigned to each device in the network to ensure communication and control between components.
Valid IP addresses can be assigned automatically using a DHCP server or manually from a list of valid IP addresses. If using
Dante audio, a separate Dante IP address must also be assigned to the receiver.
Automatic IP Addressing Mode
If using a DHCP capable Ethernet switch, set the DHCP switch to ON.
From the Device Configuration menu: Network Configuration > Next
Press the control wheel to enable editing of the Mode, and then set the mode to Automatic.
Manual IP addressing Mode
From the Device Configuration menu: Network Configuration > Next
Press the control wheel to enable editing of the Mode, and then set the mode to Manual
Set valid IP addresses and subnet values, and then press ENTER to save.
To Next Page
Loading...
