Shure Incorporated
2/42
MXA310 Table Array Microphone 4
Overview 4
General Description 4
Features 4
MXA310 Parts 4
LED Light Ring 6
Mute Buttons 7
Power Over Ethernet (PoE) 8
What's in the Box 8
Reset 9
Software Reset Options 9
MXA310 Control Software 10
Control Devices with Shure Designer Software 10
Accessing the Web Application without the Discovery App 1
0
Microphone Placement 10
Seating Scenarios 11
Permanent Table Installation 14
Installing the Cable-Exit Plug 16
MXA310 Use Cases 17
Use Designer's Auto Route 18
Microphone Configuration 19
Change the Polar Pattern 19
Aim Microphone Channels 19
Templates (Web Application) 19
Identify Channels 20
Parametric Equalizer 20
EQ Contour 23
Adjust Levels 23
When to Use the Channel and Automix Gain Faders 24
Automix Channel 25
Automix Settings 25
Automix Modes 26
Mute Sync 26
Encryption 27
Set Up the 802.1X Protocol for a Device 28
Turn Off or Clear 802.1X Settings 29
Change 802.1X Settings 29
Troubleshooting 802.1X Setup Issues 29
Networking Best Practices 29
Switch and Cable Recommendations for Dante Network
ing 30
Device IP Configuration 30
Setting Latency 30
QoS (Quality of Service) Settings 31
IP Ports and Protocols 31
Packet Bridge 32
Digital Audio Networking 33
Compatibility with Dante Domain Manager 33
Dante Flows for Shure Devices 33
AES67 34
Sending Audio from a Shure Device 34
Receiving Audio from a Device Using a Different Audio
Network Protocol 34
Using Command Strings 34
To Next Page
Loading...
