Shure Incorporated
16/87
Connect the array microphone output with a network cable to any port on the switch that supplies Power over Eth
ernet (PoE).
② Computer to network switch
Connect a computer to the network switch to control the array microphone and other networked components. The
computer also runs Dante Virtual Soundcard, Dante Controller, and the web conferencing software.
• Dante Virtual Soundcard / Controller: Turn on the Dante Virtual Soundcard and use Dante Controller to route
the array microphone signal to the computer.
• Web Conferencing Software:Assign the audio input and output device settings to the appropriate Dante trans
mitter and receiver channels.
③ Network switch to ANI4OUT
Use network cables to connect each ANI4OUT to the network switch. Each interface receives 4 channels of Dante
audio, and converts them to 4 analog signals, delivered through XLR outputs or block connectors.
④ Audio from far end to amplifier
Route the far-end audio to an amplifier.
⑤ Amplified audio signal to loudspeakers
Connect the loudspeakers to the amplifier to deliver the audio from the far end.
To Next Page
Loading...
