Shure MXA910 - Page 64

Shure Incorporated
64/87
Command String:
< SET DEVICE_AUDIO_MUTE TOGGLE >
MXA910 Response:
< REP DEVICE_AUDIO_MUTE ON >
< REP DEVICE_AUDIO_MUTE OFF >
The MXA910 will respond with one
of these strings.
Get Output Clip Status
Command String:
< GET x AUDIO_OUT_CLIP_INDICATOR >
Where x is ASCII channel number: 0
through 9. It is not necessary to con
tinually send this command. The
MXA910 will send a REPORT mes
sage whenever the status changes.
MXA910 Response:
< REP x AUDIO_OUT_CLIP_INDICATOR ON >
< REP x AUDIO_OUT_CLIP_INDICATOR OFF >
The MXA910 will respond with one
of these strings.
Flash Lights on Microphone
Command String:
< SET FLASH ON >
< SET FLASH OFF >
Send one of these commands to the
MXA910. The flash automatically
turns off after 30 seconds.
MXA910 Response:
< REP FLASH ON >
< REP FLASH OFF >
The MXA910 will respond with one
of these strings.
Get Metering Rate
Command String:
< GET METER_RATE >