EasyManuals Logo

Shure SLX D Series User Manual

Shure SLX D Series
43 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
Shure Incorporated
41/43
1.
2.
1.
2.
1.
2.
Certifications
Information to the user
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
theFCCRules.Theselimitsaredesignedtoprovidereasonableprotectionagainstharmfulinterferenceinaresidentialinstalla
tion. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device operates on frequencies shared with other devices. Consult the Federal Communications Commission White
Space Database Administration website to determine available channels in your area prior to operation.
Thisdevicecontainslicenceexempttransmitter(s)/receiver(s)thatcomplywithInnovation,ScienceandEconomicDevelop
mentCanada’slicenceexemptRSS(s).Operationissubjecttothefollowingtwoconditions:
This device may not cause interference.
This device must accept any interference, including interference that may cause undesired operation of the device.
L’émetteur/récepteurexemptdelicencecontenudansleprésentappareilestconformeauxCNRd’Innovation,Scienceset
DéveloppementéconomiqueCanadaapplicablesauxappareilsradioexemptsdelicence.L’exploitationestautoriséeauxdeux
conditions suivantes :
L’appareilnedoitpasproduiredebrouillage;
L’appareildoitacceptertoutbrouillageradioélectriquesubi,mêmesilebrouillageestsusceptibled’encompromettrele
fonctionnement.
Thesetransmittershavebeentestedandfoundtocomplywithinternationalradiationexposurelimitssetforthforanuncon
trolled environment. This equipment is in direct contact with the body of the user under normal operating conditions. These
transmitters must not be co-located or operating in conjunction with any other antenna or transmitter.
Certified under FCC Part 15 and FCC Part 74.
Certified by ISED in Canada under RSS-102 and RSS-210.
CAN ICES-3 (B)/NMB-3 (B)
Approved under the Declaration of Conformity (DoC) provision of FCC Part 15.
FCC ID: DD4SLXD1G58, DD4SLXD1H55, DD4SLXD1J52, DD4SLXD2G58, DD4SLXD2H55, DD4SLXD2J52. IC: 616A-
SLXD1G58, 616A-SLXD1H55, 616A-SLXD1J52, 616A-SLXD2G58, 616A-SLXD2H55, 616A-SLXD2J52 .
Meets essential requirements of the following European Directives:
WEEE Directive 2012/19/EU, as amended by 2008/34/EC
RoHS Directive EU 2015/863

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Shure SLX D Series and is the answer not in the manual?

Shure SLX D Series Specifications

General IconGeneral
Encryption256-bit AES
Latency3.2 ms
RF Sensitivity-97 dBm at 10-5 BER
System TypeDigital Wireless
Operating RangeUp to 100 m (300 ft) line of sight
Audio Frequency Response20 Hz – 20 kHz
Number of ChannelsUp to 32 per band
Audio Output ConnectorsXLR, 1/4"
NetworkingEthernet
RF Output Power10 mW (region dependent)
Power Requirements2 AA batteries or SB903 rechargeable battery
Battery LifeUp to 10 hours (with standard AA batteries)
DimensionsVaries by model
WeightVaries by model
Frequency Range470-952 MHz (region dependent)
Dynamic Range120 dB, A-weighted
Signal-to-Noise Ratio120 dB, A-weighted

Related product manuals