SI Analytics TITRONIC 300 - Connection of Printers; Date and Time

92
The stop bits can be set to 1, 1,5 and 2. The default setting is 1.
Abb. 84
Selecting <Reset RS Parameters> will reset the RS232 parameters to the factory settings.
5.4 Connection of Printers
The results and methods can be printed on the following media:
 HP PCL compatible printer (A4), colour (chromatic) and monochrome (e.g. laser printer)
 Seiko DPU S445 (Thermo paper 112 mm width)
 On the USB stick in PDF format
To connect the printers to the burette please use the USB socket. When printing, please check whether the
correct printer is connected. It is not possible to print "HP" printer layouts on a Seiko thermal printer or vice versa.
The printer settings should always be checked and adjusted after changing the printer.
Fig. 85
Only one printer at a time can be connected, because automatic printer recognition is not supported.
HP PCL is the default setting. If you select “Print PDF“, please make sure that a USB stick is connected to the
device. Print PDF is the default setting.
5.5 Date and Time
The factory time setting is Central European Time. This setting may be changed, where necessary: