How to adapt SICK Barcode Reader functions to local conditions?
If the functions of your SICK Barcode Reader aren't adapted to local conditions, such as incorrectly set parameters for the data interface, you should configure the device.
Why SICK CLV63 has insufficient voltage supply?
If the voltage supply to your SICK Barcode Reader is not sufficiently dimensioned or cables with too small a cross-section are used, focus on the electrical installation.
General| Brand | SICK |
|---|---|
| Model | CLV63 Series |
| Category | Barcode Reader |
| Language | English |
Specifies the intended purpose of the device as an opto-electronic ID sensor.
Lists prohibited uses and warnings for improper operation.
General safety notes to reduce health risks and avoid dangerous situations.
Details location selection, device alignment, and physical mounting.
General safety guidelines for electrical installation and connectors.
Outlines the sequence of commissioning activities.
Information on installing and using the SOPAS ET software.
Guides initial device setup using SOPAS ET.
Steps for aligning and adjusting the device for optimal reading.
Covers advanced settings like Quickstart, wizards, and evaluation tools.
Explains optical indicators (LEDs, bar graph) and button functions.
Lists common errors and their potential causes.
Methods for diagnosing faults using LEDs and system information.
To Next Page
