■
Locally at the device with the SOPAS ET configuration software. Protection of the
parameter set as a configuration file on the PC in SOPAS ET. Access to the device
via AUX interface (RS-232, or Ethernet depending on type).
■
As an alternative to the SOPAS ET configuration software, command strings are
available, upon which the operator interface of the configuration software is also
based. These are also for the triggering of device functions (e.g. reading). Docu‐
ments on the command strings can be obtained from SICK on request.
■
Centrally by the PROFINET controller via PROFINET using the GSD configuration.
Protection of the parameter set as a configuration file in the PROFINET controller.
Each time the PROFINET is restarted, the device is reconfigured.
■
Profile programming by reading a set of printed configuration bar codes. Can be
generated with the SOPAS ET configuration software.
The SOPAS ET configuration software is used for device diagnostics in case of a fault.
In normal operation, the device operates fully automatically.
8 OPERATION
62
O P E R A T I N G I N S T R U C T I O N S | CLV63x, CLV64x, CLV65x 8019588/129Z/2019-02-07 | SICK
Subject to change without notice
To Next Page
Loading...
Need help?
General
