10 Troubleshooting
10.1 Safety
DANGER
H
azard due to lack of effectiveness of the protective device
Persons and parts of the body to be protected may not be recognized in case of non-
observance.
b
Immediately shut the machine down if the behavior of the machine cannot be
clearly identified.
b
Immediately put the machine out of operation if you cannot clearly identify or allo‐
cate the fault and if you cannot safely remedy the fault.
b
Secure the machine so that it cannot switch on unintentionally.
DANGER
H
azard due to unexpected starting of the machine
b
When any work is taking place, use the protective device to secure the machine or
to ensure that the machine is not switched on unintentionally.
DANGER
H
azard due to lack of effectiveness of the protective device
Persons and parts of the body to be protected may not be recognized in case of non-
observance.
b
Do not do repair work on device components.
b
Do not make changes to or manipulate device components.
b
Apart from the procedures described in this document, the device components
must not be opened.
NOTE
A
dditional information on troubleshooting can be found at the responsible SICK sub‐
sidiary.
10.2 Diagnostic LEDs
10.2.1 Fault indicators
Overview
In t
he event of a fault, the type of fault is indicated by the light emitting diode display on
the sender or receiver.
Sender
Position of LEDs: see "Sender indicators", page 11
TROUBLESHOOTING 10
8020453/14Q7/2020-04-27 | SICK O P E R A T I N G I N S T R U C T I O N S | deTem4 Core
49
Subject to change without notice
To Next Page
Loading...
