Operating Instructions Chapter 3
DME4000
8014584/ZN33/2017-07 © SICK AG • Germany • Subject to change without notice 81
Possible settings: ± 250 m
If there is a negative measured value, “0” is output via the SSI interface.
When the preset function is activated, the offset value is overwritten if the present input is triggered;
also refer to Chapter 9.1 “Preset”.
This function monitors measured values for plausibility. Responds at light beam interruption, vehicle
speed > 10 m/s and soiling. Plausibility error results in measurement value output 0.
Check in measurement cycle
max. 200 ms.
Display of the current sensor temperature.
To Next Page
Loading...
