> Device > > Measurement laser >
Parameter Factory setting
Off, on On
8.6 Communication
I/O-Link COM selection
The IO-Link communication mode of the device can be set. Associated IODD device
description files are available on the website, see www.sick.com/OD1000.
> Communication
Parameter Factory setting
COM2, COM3 COM3
8.7 Info
Various types of status information are displayed for the device.
8.7.1 Firmware verification
The firmware version of the device is displayed.
> Info > > Firmware verification >
8.7.2 Serial number
The serial number of the device is displayed.
> Info > > Serial number >
8.7.3 Sensor operating hours
The operating hours of the device are displayed.
> Info > > Sensor operating hours >
OPERATION VIA DISPLAY 8
8019642/ZJW1/2017-04-03 | SICK O P E R A T I N G I N S T R U C T I O N S | OD1000
53
Subject to change without notice
To Next Page
Loading...
