SICK PGT-08-S User Manual

PROGRAMMING TOOL | SICK 8016223/19SR/2020-11-02
Subject to change without notice
12
PGT PGT-08-S@SOPA S
4 Connecting and programming the encoder
4.1 PGT-08-S hardware
A
A
DATA
A
DATA
B
SET
B
V/R
US
CLK
Z
CLK
Z
GND
1
2
3
No Description
1 Cable with USB connection for connecting to PC/laptop
2 Spring terminal block (for encoders with a cable outlet)
3 CablewithSUB-Dconnection(9-pin)forconnectingtoencoder-specicprogramming
cables (for encoders with connector)
4.2 Connecting PGT-08-S hardware and encoder/connection to PC
CAUTION
Risk of damage due to incorrect adapter cable!
The programming tool must only be used with the designated adapter cables (see
page 26). Other adapter cables are not permitted. Otherwise, this could result in
damage to the programming tool and/or the encoder.
1. Connect the encoder to the associated cable (see page 26).
2. Connect the cable to the PGT-08-S hardware (see page 27).
3. Connect the PGT-08-S hardware to your PC using a USB port.
Note:
The USB interface of the PGT-08-S hardware is designed solely for direct connection to
a computer. USB hubs or extensions should not be used.

SICK PGT-08-S Specifications

General

Brand	SICK
Model	PGT-08-S
Category	Media Converter
Language	English