Sicma CS/085 - 3 Unloading and Unpacking the Tiller; Tiller Protected by Heat-Shrinkable Film

- 16 -
Tiller CS
11 WIDTH INFO
000-085;
000-105;
000-125;
000-135;
000-145;
000-165;
000-185
Qt. 1
12
OIL
Oil lling point
4781008
Qt. 3
13
DOCUMENT-HOLDER CANISTER
Keep the manual inside this canister
-
Qt. 1
3. UNLOADING AND UNPACKING THE TILLER
CRUSHING HAZARD!
Qualied sta󰀨 that have read and understood the safety prescriptions must
unload the Tiller from the lorry and handle the Equipment in the work place.
These manoeuvres should be supervised by an experienced manager. In all cases,
make sure that there are no people, animals or objects in the unloading area.
The Tiller is normally transported on a lorry, sometimes without packaging,
sometimes protected by heat shrinkable lm and other times in wooden crates.
NOTE!
Before unloading the equipment from the truck, read this entire sequence in
order to be prepared for all events.
OVERTURNING AND CRUSHING HAZARD!
Tiller unloading must be carried out slowly and with the utmost care in an area
completely free from persons or objects.
RISK OF THE TILLER FALLING FROM THE TRUCK!
Recall that no matter how stable the equipment, during subsequent transportation
procedures, it must ALWAYS:
• Be well secured to the lorry, paying attention not to crush any hydraulic pipes;
• Be placed in the middle of the lorry and not near the edges, in order to avoid
losing the Tiller on the road in case it overturns due to turns or broken road,
with very serious consequences.
3.1 TILLER PROTECTED BY HEAT-SHRINKABLE FILM
Release the Tiller from any xing devices used to fasten it to the means of
transport.
Before lifting using the lorry’s lifting arm, check that all locking mechanisms (snap
hooks, shackles, etc.) and the ropes/chains used are in good condition; each
must be able to lift the weight of the machine (see weight in sec. 4 "Technical
specications").
After harnessing the Tiller, lift it a few centimetres to check the correct distribution
of weights: in case of imbalance, reposition the Tiller on the platform, correctly
adjust the harness and the length of the ropes/chains and repeat the procedure.