Sicma CS/085 - Tiller Packaged in Wooden Box

- 17 -
Tiller CS
Lift the Tiller from the deck of the means of transport to a height of approximately
30 cm, unless obstacles are present, so that it does not swing. Position the Tiller
on the ground in proximity of the tractor.
Remove the ropes and the chains from the Tiller.
Once on the ground, unpack the equipment as described below.
CUTTING HAZARD!
In the event that the Tiller arrives wrapped in a protective lm, remove
it with the aid of a cutter wearing anti-cut gloves; take care not to
injure yourself and not damage the Tiller itself.
CONTAMINATION HAZARD!
Do not dispose of the packaging in the environment, but contact
specialist collection agencies. Check the transport document or
packing list supplied and, if necessary, act as described in section 1.5
"General notes on delivery".
3.2 TILLER PACKAGED IN WOODEN BOX
If the Tiller is contained inside a wooden box, use a forklift of adequate capacity for
unloading (to ascertain the weight of the Tiller, refer to the technical specications
table in sec. 4).
Release the Tiller from any xing devices used to fasten it to the means of
transport.
Insert the forklift forks into the appropriate slots on the platform.
Lift the box from the walking surface of the means of transport by a maximum
height of 30 cm, unless hindered by obstacles.
Place the crate on the ground in the vicinity of the tractor.
With a suitable tool and wearing protective gloves, remove the wooden crate.
Harness the Tiller with ropes and/or chains of adequate capacity, lift the equipment
by a few centimetres and remove the lower part of the wooden crate. Place the
Tiller on the ground and approach the tractor in reverse so that the tractor PTO is
positioned frontally to the one of the Tiller.
Couple the Tiller to the tractor using the 3-point hitch according to section 5.1.
Check the transport document or packing list supplied and, if necessary, act as
described in section 1.5 "General notes on delivery".