Table of contents
Synchronous/induction motors 1PH813
6 Operating Instructions, 04/2009, 610.48000.22
6.2.6 Electrical connection data ........................................................................................................... 44
6.2.7 Motors with DRIVE-CLiQ interface .............................................................................................
44
6.2.8 Motors without DRIVE-CLiQ interface ........................................................................................
45
6.2.9 Connecting the temperature sensor............................................................................................
46
6.2.10 Connecting the ground conductor...............................................................................................
47
6.2.11 Connecting the separately-driven fan .........................................................................................
48
6.2.12 Connecting-up a converter..........................................................................................................
49
6.2.13 Converter operation on a grounded line supply..........................................................................
49
7 Commissioning ........................................................................................................................................
51
7.1 Measures prior to commissioning ...............................................................................................
51
7.2 Performing a trial run...................................................................................................................
53
7.3 Checking the insulation resistance .............................................................................................
54
7.4 Switching on the motor................................................................................................................
56
7.5 Cooling ........................................................................................................................................
57
8 Operation.................................................................................................................................................
59
8.1 Safety instructions during operation............................................................................................
59
8.2 Stoppages ...................................................................................................................................
60
8.3 Shutdown ....................................................................................................................................
60
8.4 Faults...........................................................................................................................................
61
9 Maintenance ............................................................................................................................................
63
9.1 Inspection and maintenance .......................................................................................................
63
9.1.1 Safety information .......................................................................................................................
63
9.1.2 Maintenance intervals .................................................................................................................
65
9.1.3 General inspection guidelines.....................................................................................................
65
9.1.4 Initial inspection...........................................................................................................................
66
9.1.5 General inspection ......................................................................................................................
66
9.1.6 Rolling-contact bearings..............................................................................................................
66
9.1.7 Bearing replacement intervals.....................................................................................................
67
9.1.8 Cleaning the fan (forced ventilation) ...........................................................................................
67
9.2 Repair..........................................................................................................................................
69
9.2.1 Safety information .......................................................................................................................
69
9.2.2 Removing/installing the motor.....................................................................................................
70
9.2.3 Removing/installing the external fan ...........................................................................................
71
9.2.4 Removing/installing the rotor encoder ........................................................................................
74
9.2.5 Replacing the DRIVE-CLiQ interface (encoder module) ............................................................
76
9.2.6 Tightening torque for screwed connections ................................................................................
76
10 Spare parts..............................................................................................................................................
77
11 Decommissioning and disposal ...............................................................................................................
81
11.1 Decommissioning........................................................................................................................
81
11.2 Disposal.......................................................................................................................................
83
11.2.1 Introduction .................................................................................................................................
83
11.2.2 Preparing for disassembly...........................................................................................................
83
11.2.3 Dismantling the motor .................................................................................................................
83
11.2.4 Disposing of permanent magnets ...............................................................................................
84
11.2.5 Disposing of components............................................................................................................
84
11.2.6 Disposing of insulating liquid.......................................................................................................
85
To Next Page
Loading...
