Siemens 7MC3040-... - Terminal Connection via USB; Terminal Connection via RS485

s
Operating manual PA
37
General Functions (configuration layer: C011)
Parameter
Function
Explanation
LED.G
Green status LED
ON LED indicates 24V
DO1 LED indicates digital output 1
DO2 LED indicates digital output 2
TAC1 LED indicates running measurement in
mode for ADT function
PILO.
Activate laser*
INT keypress
OFF laser disabled
T.DI1 edge-triggered, switching input 1
T.DI2 edge-triggered, switching input 2
PIL.T
Laser ON-time*
1-15: select auto laser shut-off in minutes
TERM.
Assign Interface
OFF non-terminal mode
USB terminal mode at USB interface
R485 Terminal mode at RS485 (Halbduplex)
A.STR.
Automatic tempera-
ture data output
OFF automatic temp. data output is off.
ON temp. data output at PC terminal
A.CYC.
Cycle for automatic
temp. data output
Select cycle time in s
ADDR.
Device address
Enter address of device for non-terminal mode
DISP.
Display panel**
"ON" the display panel indicates “on“
IA1 indicate temperature of source Ao1
UNIT
temperature scale
°( degrees Celsius
°F degrees Fahrenheit
C.OVL.
Screen insert tem-
perature reading**
ON On
OFF Off
C.TBC.
TBC exposure me-
tering**
“ON” spot weighted
“OFF” average
C.COL.
White balance**
“DAYL.” daylight
“AUTO.” automatic
SAVE
Save
Save changes / exit menu
ESC
Escape
Discard changes / exit menu
* only available for models with laser sighting
** only available for models with camera
Displayed temperature readings (Configuration layer: C020)
Parameter
Function
Explanation
L1.
Temp. reading
Lambda1
Shows current temperature reading for L1
L1.PR.
Reading Lambda1
without peak picker
Shows current temperature reading for L1 prior to
peak picker
T.INT.
Inner temperature
Current inner temp. of device
AIN
Initial value at ana-
logue input
Current value of analogue input when activated
ESC
Escape
Exit menu