Siemens 7VK512

)NSTALLATION INSTRUCTIONS6+
6

#
' #
)F ONE TRIES TO LEAVE THE SETTING RANGE FOR THE CONFIGU
RATION BLOCKS IE ADDRESS BLOCKS  TO  WITH KEYS
ÅÇ THE DISPLAY SHOWS THE QUESTION
%.$ /&
#/$%7/2$ /0%2!4)/. 
 0RESS THE .O KEY
. TO CONTINUE CONFIGURATION )F YOU PRESS THE
9ES KEY *9 INSTEAD ANOTHER QUESTION APPEARS
3!6% .%7 3%44).'3   .OW YOU CAN CONFIRM
WITH *9 OR ABORT WITH . AS ABOVE
7HEN ONE EXITS THE SETTING PROGRAM THE ALTERED PA
RAMETERS WHICH UNTIL THEN HAVE BEEN STORED IN BUFFER
STORES ARE PERMANENTLY SECURED IN %%02/-S AND
PROTECTED AGAINST POWER OUTAGE )F CONFIGURATION PA
RAMETERS HAVE BEEN CHANGED THE PROCESSOR SYSTEM
WILL RESET AND RE
START $URING RE START THE DEVICE IS
NOT OPERATIONAL
 /0%2!4).'
0!2!-%4%23
"EGINNING OF THE BLOCK /PERATING PARAMETERS
 ,!.'5!'%
$%543#(
%.',)3(
4HE AVAILABLE LANGUAGES CAN BE CALLED UP BY REPEATEDLY
PRESSING THE
.O KEY . %ACH LANGUAGE IS SPELLED IN
THE CORRESPONDING COUNTRY
S LANGUAGE )F YOU DON T UN
DERSTAND A LANGUAGE YOU SHOULD FIND YOUR OWN LAN
GUAGE
4HE REQUIRED LANGUAGE IS CHOSEN WITH THE ENTER KEY %
 /0%2"!5$2
 "!5$
4HE TRANSMISSION "AUD
RATE FOR COMMUNICATION VIA THE
OPERATING INTERFACE AT THE FRONT CAN BE ADAPTED TO THE OP
ERATOR
S COMMUNICATION INTERFACE EG PERSONAL COM
PUTER IF NECESSARY 4HE AVAILABLE POSSIBILITIES CAN BE DIS
PLAYED BY REPEATEDLY DEPRESSION OF THE
.O KEY .
#ONFIRM THE DESIRED "AUD
RATE WITH THE ENTRY KEY %
.OTE &OR OPERATOR PANEL 82 THE OPERATION "AUD
RATE MUST BE  "!5$
 "!5$
 "!5$
 "!5$
 "!5$
 $!4% &/2-!4
$$--9999
4HE DATE IN THE DISPLAY IS PRESET TO THE %UROPEAN FORMAT
$AY-ONTH9EAR 3WITCH
OVER TO THE !MERICAN FORMAT
-ONTH$AY9EAR IS ACHIEVED BY DEPRESSING THE
.O KEY . THEN CONFIRM WITH THE ENTRY KEY %
$$ TWO FIGURES FOR THE DAY
-- TWO FIGURES FOR THE MONTH
9999 FOUR FIGURES FOR THE YEAR INCL CENTURY
--$$9999
 &!5,4 ).$)#
7)4( &!5,4 $%4%#
3TORED ,%$ INDICATIONS AND THE FAULT EVENT MESSAGES IN
THE DISPLAY CAN BE DISPLAYED EITHER WITH EACH FAULT DE
TECTION OR ONLY AFTER TRIP COMMAND IS GIVEN 4HIS MODE
CAN BE CHANGED BY DEPRESSING THE
.O KEY . AND
CONFIRMED WITH THE ENTER
KEY %
7)4( 42)0 #/--