Siemens 7VK512

6+
)NSTALLATION INSTRUCTIONS
6

#
' #
 /0%2 ST ,
5 
-ESSAGE TO BE DISPLAYED IN THE ST DISPLAY LINE DURING
OPERATION !NY OF THE OPERATIONAL MEASURED VALUES AC
CORDING TO 3ECTION  CAN BE SELECTED AS MESSAGES
IN THE THE QUIESCENT STATE OF THE RELAY BY REPEATEDLY DE
PRESSING THE
.O KEY . 4HE VALUE SELECTED BY THE
ENTRY KEY % UNDER ADDRESS  WILL APPEAR IN THE FIRST
LINE OF THE DISPLAY
5 
ETC
 /0%2 ND ,
5 
-ESSAGE TO BE DISPLAYED IN THE ND DISPLAY LINE DURING
OPERATION 4HE VALUE SELECTED BY THE ENTRY KEY % UNDER
ADDRESS  WILL APPEAR IN THE SECOND LINE OF THE DIS
PLAY
ETC
&AULT EVENT ANNUNCIATIONS CAN BE DISPLAYED AFTER A
FAULT ON THE FRONT 4HESE CAN BE CHOSEN UNDER AD
DRESSES  AND  4HE POSSIBLE MESSAGES
CAN BE SELECTED BY REPEATEDLY PRESSING THE
.O KEY . 4HE DESIRED MESSAGE IS CONFIRMED
WITH THE ENTER KEY % 4HESE SPONTANEOUS MESSAGES
ARE ACKNOWLEDGED DURING OPERATION WITH THE 2%3%4
KEY OR VIA THE REMOTE RESET INPUT OF THE DEVICE !FTER
ACKNOWLEDGEMENT THE OPERATIONAL MESSAGES OF THE
QUIESCENT STATE WILL BE DISPLAYED AGAIN AS CHOSEN
UNDER ADDRESSES  AND 
 &!5,4 ST ,
!2 )NIT 4YPE
!FTER A FAULT EVENT THE FIRST LINE OF THE DISPLAY SHOWS
TYPE OF !2 INITIATION FAULTY PHASES
TYPE OF CLOSING COMMAND SINGLE
OR THREE POLE
!2 #LOSE 4YPE
 &!5,4 ND ,
!2 #LOSE 4YPE
!FTER A FAULT EVENT THE SECOND LINE OF THE DISPLAY SHOWS
THE POSSIBILITIES ARE THE SAME AS UNDER ADDRESS 
ETC
 $%6)#% !$$

)DENTIFICATION NUMBER OF THE RELAY WITHIN THE SUBSTATION
VALID FOR BOTH THE INTERFACES OPERATING AND ,3!
INTERFACE 4HE NUMBER CAN BE CHOSEN AT LIBERTY BUT
MUST BE USED ONLY ONCE WITHIN THE PLANT SYSTEM
3MALLEST PERMISSIBLE NUMBER 
,ARGEST PERMISSIBLE NUMBER 
 &%%$%2 !$$

.UMBER OF THE FEEDER WITHIN THE SUBSTATION VALID FOR
BOTH THE INTERFACES OPERATING AND ,3! INTERFACE
3MALLEST PERMISSIBLE NUMBER 
,ARGEST PERMISSIBLE NUMBER 