Siemens AOP - AOP Set-up & Configuration; Setup Menu Options

26
AOP Operating Instructions – Issue 07/05
6SE6400-5AP00-0BB0
The parameter sets are identified numerically, from 00 to 09, a total 10 sets.
A parameter set can only be edited if the set contains parameter data. If the
chosen parameter set does not contain parameter data the user will be asked to
confirm if they wish the default parameter set to be copied to the new location.
On confirmation of this instruction, only the editable parameters will be copied to
the new location - read only parameters will be called from the original location.
To edit the parameter sets the following procedure should be performed:
1. From the Main Menu scroll through the list of options using the
and
keys until ‘MODE’ is highlighted.
2. Press the
key to confirm the selected option.
The user is then presented with the mode option screen.
3. Using the
and keys highlight ‘INTERNAL’.
4. Press the
key to confirm the selected option.
The user is then presented with the Internal mode menu screen.
5. Using the
and keys highlight ‘PARAMETERS’.
The user is then presented with the internal edit menu for the AOP.
6. Using the
and keys highlight required parameter set
number.
The parameters can now be edited using the procedures outlined in Sections
6.1 and 6.3 above.
6.5 Engineering
When in Internal Mode of operation an additional menu item is available at the
top-level.
This menu allows the user to view a USS message log of the last 1k bytes of
messages between the AOP and the connected inverters.
7 AOP Set-up & Configuration
7.1 Setup Menu
Using the Setup option from the Main Menu of the AOP, the following
characteristics of the AOP can be personalized by the user:
¾ Backlighting
¾ Screen Contrast
¾ Large Numbers
¾ Cursor Type
¾ Start Help
¾ Welcome Text
¾ Parameter Set Names (Expert Level and above only)
¾ Set Time/Date (Service Level only)
¾ AOP Reset