29
AOP Operating Instructions – Issue 07/05
6SE6400-5AP00-0BB0
The user will then be presented with a text screen with the first character
highlighted by the cursor. The text string can contain a maximum of 20
characters.
1. Using the and keys scroll through the characters until the
desired character is shown.
2. Press the
key to accept the character and move to the next
character.
3. Repeat steps 1 and 2 until the desired text is entered.
4. Press and hold the
key to except the text string and return to
the Setup menu
Pressing and holding down the
key will cancel the text entry, restore the
original text string and return the user to the Setup menu.
Pressing the and keys simultaneously, at any time will display
the relevant help screens to assist the user.
7.1.7 Parameter Set Names
This function allows the user to edit the parameter set names. All ten parameter
sets can be edited. This option is not available in the standard access level.
To edit the parameter set names, the following procedure should be performed:
1. Using the
and keys select the ‘Parameter Set Names’
option from the Setup menu.
2. Press the
key to confirm.
The user is then presented with the Parameter Set Names screen.
3. Using the
and keys select the required parameter set.
4. Press the
key to confirm the parameter set.
The text string of the parameter set name is then edited using the same
procedure as given in Section 8.1.5.
Pressing and holding down the
key will cancel the text entry, restore the
original text string and return the user to the Setup menu.
Pressing the and keys simultaneously, at any time will display
the relevant help screens to assist the user.
To Next Page
Loading...
