Siemens AOP - Time;Date Setting and AOP Reset; AOP Reset Procedure

30
AOP Operating Instructions – Issue 07/05
6SE6400-5AP00-0BB0
7.1.8 Set Time/Date
The set time and date option from the Setup menu allows the user to set the
correct date and time of the AOPs simple watch function.
To set the correct time and date, the following procedure should be performed:
1. Using the
and keys scroll through the option on the Setup
menu until ‘Set Time/Date’ option is highlighted.
2. Press the
key to confirm the selection.
The user is then presented with the Set Time screen:
The first time element is highlighted.
3. Using the
and keys scroll through the digits until the
desired hour is highlighted.
4. Press the
key to confirm the selection.
The cursor then automatically moves to the minutes field.
5. Repeat steps 3 and 4 until the minutes and seconds are set to the
correct time.
The Day/Date screen is then displayed.
6. Complete steps 1 to 5 above to set the correct Day/Date.
7. Press and hold the
key to accept the Day/Date settings and
return to the Setup menu.
7.1.9 AOP Reset
Warning
This function deletes all parameter sets and settings stored within the
AOP
The AOP reset is accomplished by selecting the ‘AOP Reset’ option from the
Setup menu.
The normal default for this function is to clear all internal faults, message logs
and the stored parameter sets.
To initiate an AOP reset, the following procedure should be performed:
1. Using the
and keys select the ‘AOP Reset’ option from the
Setup menu.
2. Press
to confirm.