Siemens CP1430 TCP - Page 28

2 Engineering
Ethernet Communication (ISO on TCP) between SIMATIC S5 and
SIMATIC S7-1500 Controllers
Entry-ID: 109482475, V1.2, 07/2019
28
© Siemens AG
2019 All rights reserved
To do this, proceed as follows:
1. Start the STEP 5 V 7 Engineering Software.
Start the CP1430 TCP software NCM COM 1430 TCP via "Wechsel”
["Change”] > "weitere…” ["Further programs”] or by pressing the F9 key.
2. Start the configuration tool "NCM package COM 1430 TCP”.