Siemens CP1430 TCP User Manual

2 Engineering
Ethernet Communication (ISO on TCP) between SIMATIC S5 and
SIMATIC S7-1500 Controllers
Entry-ID: 109482475, V1.2, 07/2019
12
© Siemens AG
2019 All rights reserved
2 Engineering
Overview
The following chapters will give you a detailed overview of all communication
variants.
Table 2-1
SIMATIC S5 - CP1430 TCP
S5 service
Active
FETCH/WRITE
SEND/
RECEIVE
Bidirectional
S7-1500
service
Passive
FETCH/WRITE
OUC
programmed
via
compact
instruction
OUC
programmed
via
single
instructions
OUC
parameterized
via
single
instructions
via
CP1543-1
Scenario 1
Scenario 3
Scenario 4b
Scenario 4a
via
S7-1500 CPU

Scenario 5
Scenario 2b
Scenario 2a
2.1 Hardware setup
The description of the hardware installation is divided into setting up the SIMATIC
S7-1500 and the SIMATIC S5 hardware. The example setup includes all example
scenarios described in chapter 2.
Prerequisites
Two programming devices are used for the commissioning of this application
example. This is necessary, because the engineering software of the SIMATIC S7
and of the SIMATIC S5 requires a different Windows operating system.
Programming device with STEP 5 V 7: Windows XP
Programming device with TIA Portal STEP 7 V 15.1: Windows 7
Please make sure that the IP addresses used in the project do not overlap with
other Ethernet nodes or are used several times.

Siemens CP1430 TCP Specifications

General

Brand	Siemens
Model	CP1430 TCP
Category	Controller
Language	English