Miscellaneous functions
111
Step by step
j w
The remote programmer must now enter the system’s
password on an MF telephone (the default is 31994)
and wait for a confirmation tone.
j w To set the required configuration, proceed as if the re-
mote telephone were locally connected to the system.
If there is a DID installed
If the system is equipped with a Fax/DID module pro-
grammed as an external line DID.
*95 w Enter the code using a remote MF telephone after the
call is answered.
j w The remote programmer must now enter the system’s
password on an MF telephone (the default is 31994)
and wait for a confirmation tone.
j w To set the required configuration, proceed as if the re-
mote telephone were locally connected to the system.
Using the HiPath 1100 Manager application
1
Required:
• Analog line: The system’s serial port and the remote
PC must be connected to a modem with access to
the telephone network.
• Digital line: The S
0
optional module must be con-
nected to an ISDN-type digital line, and the remote
PC must have an ISDN modem installed and con-
nected.
N Press this key.
Select and confirm.
or
*992 Enter the code to enable remote configuration/updating
in the programming extension.
If an external programmer does not carry out the
programming within a specified time period, the
remote configuration process times out.
[1] The system must be activated during a conversation by configuring
certain parameters (see General programming - remote configura-
tion in the Programming manual). For further information on how
to use the HiPath 1100 Manager application refer to the instruc-
tions in the Help file.
MORE FEATURES? f
*992= REMOTE ADMINISTRA-?
To Next Page
Loading...
