Step by step
Functions used when making calls
34
Callback
1
This makes it possible for a call to be made automatical-
ly to an extension or external number (through a digital
line) which is temporarily unavailable as soon as it be-
comes is available.
Required: The destination number is not available.
Callback due to no answer/busy
Confirm.
or
*58 Enter the code to confirm the recall.
or
Wait 7 s
w Wait 7 seconds until you hear a distinctive tone (when
configured, Recall will be activated automatically).
w Wait for a confirmation tone.
\ Replace the handset.
or
n Press this key. The LED goes off.
w Wait for the recall.
If Callback has been deactivated during configura-
tion, do the following to activate it:
2
:
Wait a few seconds until the display shows "CALLBACK
ENABLED?" and the busy signal or the call is briefly in-
terrupted.
\ Replace the handset.
or
[1] Extension is busy – the system generates a recall as soon as a line
is available.
Extension is free – the system generates a recall once the caller
has returned to the station and made a call.
External number is busy - The system generates a recall as soon
as the destination number is free. This feature must be activated
by the carrier and the system needs to have a S
0
module installed.
Only one recall can be activated for each extension. A new recall
cancels the previous one.
CALLBACK?
[2] (See Activating Callback/urgent call with timeout, in the program-
ming manual)
CALLBACK ENABLED?
To Next Page
Loading...
