Siemens HiPath 1120 - System Management Utilities

Step by step
Miscellaneous functions
96
Relay
1
The relay on the HiPath 1120 music module is used to con-
trol all peripheral equipment, such as the door opener, etc.
N Press this key.
Select and confirm.
or
or
*90
or #90 Enter the code to activate or deactivate the relay.
If a Fax/DID feature was configured...
The relay can be controlled by a remote MF telephone
Required: The remote telephone must have a conver-
sation in progress with the system’s programming ex-
tension.
N Press this key.
Select and confirm.
or
or
*90
or #90 Enter the code to activate or deactivate the relay.
j Enter the system password at the remote telephone
(the default is: 31994).
[1] Activate (contacts closed) or Deactivate (contacts open) the relay
immediately or after a specified time (see Programming manual,
Relay and Sensors in HiPath 1120).
*90= CONTROL RELAY ON?
*90= CONTROL RELAY OFF?
*90= CONTROL RELAY ON?
*90= CONTROL RELAY OFF?