Siemens LME72.000A2 - Page 191

191/245
Building Technologies Division Basic Documentation LME7... CC1P7105en
Infrastructure & Cities Sector 23 Operation via AZL2… 29.11.2011
/
reset
Press
/
reset
to activate the restore process.
Display shows run
<3 s
After approx. 3 seconds (depending on the duration of the
program sequence), the displays shows rSt End and
signaled the end of the restore process.
Display: rSt End
It will now be displayed for 2 minutes, or can be finished by pressing the
/
reset
button

<2
min
or
/
reset
Display shows OFF when the restore process is finished.

Note:
During the restore process, all settings and parameters are written from the program module to
the basic unit’s onboard memory. In the process, it is possible that previous program
sequences, parameters and settings in the onboard memory will be overwritten!
Warning!
On first startup or after exchange of the program module, the sequence of functions and
parameter settings must be checked upon completion of the restore process. If this is not
observed, there is a risk of loss of safety functions.
 See chapter Operation via AZL2.../first startup, restore
 See chapter Operation via internal LED/first startup, restore