Siemens MAG 6000 - Operator Menu Setup

71
SITRANS F M
8. Commissioning
0HQX
0HQX
7H[W
6HQVRUVL]H
7H[W
6HQVRUW\SH
(UURU
SHQGLQJ
6WDWXVORJ
Menu setup
8.4.9
Operator menu setup
The upper line is always active and can never be deselected.
The two lower lines are for individual operator information. Information which the operator can scroll
through with the forward key
.
• A
in the operator menu setup, means that the menu is enabled when viewing the operator menu.
• A
means that the menu is not available in the operator menu.
The middle line can either be used as a heading “Text line” for the lower line, or as a flow reading.
A flow reading can be individually selected for each menu.
The lower line may be used for an additional flow reading to the reading already available in the
upper line.
Text means that the text for the chosen measured value is
shown.
For example if text is chosen in line 2 and flow rate is chosen in
line 3, the text “flow rate” is shown in line 2 and the measured
flow rate value is show in line 3.