Siemens MOBILETT Plus - Friction Linings Replacement

MOBILETT Plus / - E/ - M SPR8-215.898.01 Page 24 of 28 Siemens-Elema AB
Rev. 05 01.02 SPS-UD Solna, Sweden
10 - 24 Mechanical systems
Replacing the friction linings 10
Replacing the horizontal friction lining 10
• Remove the joint covers.
• Remove the locking nut.
• Remove the screw and the disc springs.
• Replace the horizontal friction lining.
• Remount the screw and the the disc springs (fig. 27). Secure the screw with the locking
nut.
• Adjust the horizontal friction linings. Refer to the section: "Adjustment of the friction
linings", Page 10 - 4.
• Reattach all covers.
Fig. 27
Locking nut
Disc springs
Friction lining