Siemens MOBILETT Plus - Tension Adjustment

Motor drive units 11 - 3
Siemens-Elema AB SPR8-215.898.01 Page 3 of 6 MOBILETT Plus / - E/ - M
Solna, Sweden Rev. 05 01.02 SPS-UD
Tension adjustment 11
• Loosen the screws (A/Fig. 4). The tension of the transmission belt can then be adjusted
with a 13 mm wrench.
• Press the special adjustment device to the transmission belt and hold a finger on top of it.
When the button (C/Fig. 5) is in the same level as the top of the adjustment device a
proper pressure is applied.
Fig. 4 Fig. 5
C
M
O
B
0
0
4
6
0
A
1 - 1.5 mm