Siemens MOBILETT Plus - Collimator Replacement and Repairs; Collimator Lamp Replacement

9 - 1
Siemens-Elema AB SPR8-215.898.01 Page 1 of 8 MOBILETT Plus / - E/ - M
Solna, Sweden Rev. 05 01.02 SPS-UD
Replacing the collimator lamp 9
• Remove the cover (1) by removing the screws (4) marked "A" (Fig. 1). Turn the collimator
around so that the lamp housing is in front of the cover opening.
• Remove the protective plate (2), covering the collimator lamp by loosening, not
removing, the screws marked "B" one turn. Do not adjust screws "C", "D", or "E" (Fig. 2).
• Remove the defective lamp and replace it with a new lamp (Fig. 3). Do not touch the
bulb with bare fingers. (See "list of spare parts".)
• Reinstall the protective plate. Tighten the screws marked "B".
Fig. 1 Fig. 2
Fig. 3
Equipment required: Lux meter
75
75
75
75
90
90
7
5
75
7
5
75
6
0
60
4
5
45
3
0
30
15
15
0
1
5
15
30
30
45
45
6
0
60
7
5
75
9
0
90
7
5
75
MOB00475
B
D
E
B
2
C
MOB00474
A
A
A
A
1
Replacement and repairs on the collimator 9