Siemens MOBILETT Plus - Mains Cable and Cable Winder Replacement

Miscellaneous 8 - 3
Siemens-Elema AB SPR8-215.898.01 Page 3 of 6 MOBILETT Plus/ - E/ - M
Solna, Sweden Rev. 05 01.02 SPS-UD
Replacement of mains cable/cable winder 8
• Remove side covers and the cover with the cassette compartment.
• Remove the four (two on each side) screws that fixes the cable winder assembly
(pos. 1 / Fig. 2).
• Pull out the cable winder assembly approximately 10 cm.
• Disconnect main switch plug K52 (pos. 1 / Fig. 3).
Fig. 2 Fig. 3
Sharp edge!
The brake handle could be damaged.
Lock the brake handle, otherwise it is damaged by the sharp
upper edge of the cable winder assembly.
MOB00618
1
MOB00619
1
CAUTION