1 - 1
Siemens-Elema AB SPR8-215.898.01 Page 1 of 6 MOBILETT Plus / - E/ - M
Solna, Sweden Rev. 05 01.02 SPS-UD
General 1
Training of customer support engineers 1
Due to the technology used in this equipment, setup, service and maintenance should be
performed only by customer support engineers who have a work authorization for
MOBILETT Plus.
Text emphasis 1
Symbols 1
Checks and adjustments that must be performed with radiation ON are identified by the
radiation warning symbol.
This symbol means "Dangerous voltage".
This symbol means "Attention, consult the documentation".
This symbol means: equal to or less than.
Several of the sections in these instructions are for the USA only. These sections are
identified with this symbol.
Sections marked with this symbol have been included in the Siemens Training Video
(part of the self-study packet), which can be ordered through Siemens customer service.
DANGER indicates when there is an immediate danger that leads
to death or serious physical injury.
WARNING indicates a risk of danger that may lead to death or to
serious physical injury.
CAUTION used with the safety alert symbol indicates a risk of
danger that leads to slight or moderate physical injury and/or
damage to property.
NOTICE used without the safety alert symbol indicates a risk of
danger that if disregarded leads or may lead to a potential situa-
tion which may result in an undesirable result or state other than
death, physical injury or damage to property.
NOTE contains information provided with special emphasis to
facilitate proper use of the equipment or proper execution of a
procedure, i.e. hints, tips.
U
S
A
To Next Page
Loading...
