Display messages 2 - 19
Siemens-Elema AB SPR8-215.898.01 Page 19 of 22 MOBILETT Plus / - E/ - M
Solna, Sweden Rev. 05 01.02 SPS-UD
Err 38
The mes-
sage is not
shown to
the opera-
tor. This
message
can only
be read
out from
the mes-
sage his-
tory, P08.
Generator ON The error statistics
are lost.
See "Err 37". If "Err 38" is the only
message in the history memory, it
will not be necessary to replace
D1. These statistics are only used in
the factory.
PC NodE The switch S:1 on
board D1 is set in the
wrong position.
This mode is only used at the factory.
To quit this mode; put switch S1:2 in
the OFF position.
Dis-
played
messages
Mode of
operation
Cause Possible reason
* See section "Monitoring the kV- and mA-controls"
** Wiring diagram X037E
Tab. 1
To Next Page
Loading...
