MOBILETT Plus / - E/ - M SPR8-215.898.01 Page 10 of 28 Siemens-Elema AB
Rev. 05 01.02 SPS-UD Solna, Sweden
10 - 10 Mechanical systems
• Tighten screws (2) and (3).
• Tighten the adjustment screw until the arm and single tank are held in the uppermost
position by the spring force alone.
MOBILETT Plus and Plus M only
The installation of the turn plate is performed in the reverse order.
• Install the turn plate.
• Reattach the shafts.
• Reattach the bearing rings.
• Reattach the locking rings.
• Connect the ground cable and K68.
All MOBILETT:s
• Reinstall the supporting wheels behind the tilt bar.
• Reattach the tilt bar.
• Remove the ceiling support carefully and check that the single tank remains in the
uppermost position by itself. If not, tighten the adjustment screw.
• Move the arm into the park position.
• Lower the unit to the floor and block the rear wheels.
• Check the arm and single tank movement. If necessary, adjust according to section
"Adjustment of the arm system".
• Reattach all covers except the top cover.
• Set switch S10 in the ON position to charge the capacitor bank.
• Reattach the top cover.
• Check the function of the turn plate and the unit by releasing one exposure.
To Next Page
Loading...
