Siemens MTCO 1324 - Chart Removal Procedure

© Siemens VDO Automotive AG 29
Removing the charts
Remove your chart from the MTCO 1324
• in case of a change of driver or vehicle,
• at the end of the working time
• or after 24 hours at the latest.
 Press key.
½ The "Ejection active"symbol is shown
in the display. A process indicator sig-
nals that the records on the charts are
being completed by the MTCO 1324.
½ Wait until the drawer has been
unlocked.
 Pull out the blocked drawer to limit stop,
or, in addition, tip down the hinged
drawer.
 Remove the charts and complete the
inscription in the centre field,
➥ see page 37.
 Push in drawer until it locks into place.
Bring the hinged drawer into a horizon-
tal position beforehand.
Comment
In case you have, however, switched off the
ignition, it is possible that the drawer does not
properly lock after closing. In this case, please
proceed as follows:
 Switch on the ignition.
½ Wait until the ejection procedure has
been finished.
 Then push in the drawer until it locks into
place.
 Switch off the ignition again.
Automatic switching off of the time
group and the distance recording
In case the drawer remains closed with the
charts inserted for more than 25 hours, the
MTCO 1324 automatically records the time
group " " for driver 1 and 2. The MTCO
thus goes easy on the vehicle battery.
Notes on a standstill of the vehicle
The drawer may only be opened,
if ...
• the vehicle is at a standstill and
• the ignition is switched on.
Please do not switch off the igniti-
on while the "Ejection active" symbol
is shown on the display!
If the vehicle has not been used for a
long time, please make sure that
there is no chart in the MTCO 1324;
e.g. in case of maintenance or repair
work or immobilisation of the vehicle.