© Siemens VDO Automotive AG 31
Adjusting the time
• The function TIME ADJUSTMENT may
only be selected if the vehicle is station-
ary.
• For an automatic synchronisation of the
chart carrier and the time, the ignition
has to be switched on and there must
not be any chart inserted in the
MTCO.
= Depress key shortly
= Depress key for a longer interval
Select the TIME ADJUSTMENT via .
Activate the minutes counter via or ,
the minutes start to flash.
Depress or key until the desired value
is being displayed.
Activate the hours counter via , the hours
start to flash.
Depress or key until the desired value
is being displayed.
½ When exceeding or undershooting 12 p.m.,
the date will be adjusted automatically.
Acknowledge the time adjustment by depressing
the key for more than 2 seconds. The basic
display will then be shown again.
Comment
If you adjust the time while a chart is inserted, the er-
ror symbol will be shown in the display and the time
will be flashing. The MTCO will remind you to update
the chart carrier settings; ➥ see page 34.
To Next Page
Loading...
