© Siemens VDO Automotive AG 33
Error code - Overview
➥ To be continued on the next page
Displayed message Code Meaning / measure
(Time is flashing)
9053
or
= • The MTCO 1324 has automatically changed over
to the beginning or the end of the daylight saving
time,
• or the time has been adjusted with the chart
inserted.
Note: update the chart carrier settings,
➥ see page 34.
9064
= Error during chart carrier settings update
Update the chart carrier settings once again,
➥ see page 34.
(Colon is not flashing)
9064
= Error in the driving mechanism of the chart carrier
Check whether the charts have been correctly
inserted.
A050
= Trip without driver 1 chart
(Error code cannot be found in the error memory.)
Insert driver 1 chart.
9051
9052
=
=
Driver 1 chart is missing
Driver 2 chart is missing
(This message will appear when switching from to
, for example, while the chart is missing.)
Insert chart(s).
900A
900B
= Error during CAN transmission
A00C
= Internal error
900F
= Keypad error, key pressed too long or blocked
9010
= LCD error (display)
9060
= Error at the drawer
Start the ejection procedure and close the dra-
wer again afterwards.
To Next Page
Loading...
