Siemens MTCO 1324 - Indicating Instrument; Reset Trip Odometer to Zero

© Siemens VDO Automotive AG 35
Indicating instrument (Page 150, figure III)
Comment
Design and functions may deviate from this
indicating instrument (E-Tacho 1323),
for detailed information, please refer to the
respective operating instructions.
1) Vehicle speed display
2) Function monitor
If the LED is lit up, there is a failure or
an event, e.g. a chart is missing or one of
the system’s components does not work
properly.
3) LC-Display
(Display for Ignition On)
• 7 digit display of the total distance
travelled, with the last digit indicating
the 100-metre-distances.
• In the bottom line, either the time or
the trip odometer is displayed.
4) Reset key
Key for switching over from time to trip
odometer.
Reset trip odometer to zero
In the second line of the LC display, the most
recently selected option is displayed: Time or
the trip odometer reading.
 Set the display to "Trip odometer
reading" and press the reset key for a
short time, if appropriate.
 Then depress the reset key for more than
2 seconds.
½ The trip odometer will be reset to "0".
Comment
You may also reset the trip odometer during
ride.