Using Other Functions/Services
43
Step by Step
• Lock and unlock all phones,
code:
*
66/#66 Æ Page 36
•Save PIN,
code:
*
93 Æ Page 37
• Send a message,
code:
*
68/#68 Æ Page 38
• Group ringing, code:
*
81/#81 Æ Page 48
• Group call, code:
*
85/#85 Æ Page 47
• Suppress caller ID,
code:
*
86/#86 Æ Page 34
• Open door, code:
*
61 Æ Page 19
• Door opener on/off, code:
*
89/#89 Æ Page 20
• Control relay, code
*
90/#90 Æ Page 45
• Do not disturb, code:
*
97/#97 Æ Page 34
• Speed-dialing, code:
*
7 Æ Page 21
• Associated service, code:
*
83 Æ Page 42
Precondition: You have a telephone that uses tone di-
aling (DTMF dialing) or you can switch your telephone
to tone dialing. The telephone is not connected to the
system.
o Set up a call to the system. Enter the station number
(contact the service personnel).
o Wait for a continuous tone (if necessary switch the tele-
phone to tone dialing), then enter the internal number
that has been assigned to you and the associated PIN.
r Enter the code (necessary only if programmed in the
system).
o Wait for a dial tone and then enter the code, such as
*
97 for Do not disturb on. Make other inputs as
necessary; (refer to the operating instructions for pulse
and DTMF telephones).
or
o Dial the external number.
You can only execute one function at a time, or
set up only one outgoing connection.
The connection is immediately released after
successful activation of a function.
In the case of an external-external call, the
connection is released as soon as either of the
parties ends the call.
To Next Page
Loading...
