Siemens optiPoint 500 entry - Controlling Relays

Step by Step
Special Functions in the LAN (Not for HiPath 500)
56
Controlling Relays
If this feature is configured (contact the service person-
nel, you can also control relays Æ Page 45 in other
HiPath 3000 communications platforms.
n Lift the handset.
qhk Enter the code.
o Enter the (DISA) call number of the HiPath 3000 in
which the relay is to be controlled.
r Enter.
o Enter the (DISA) call number of the telephone from
which you wish to control the relay.
r Enter.
qmd or rmd Enter the code for "on" or "off".
e ... h w Enter the relay.