Changing the orientation of the rear terminals for main circuit connection (vertical/horizontal)
on the guide frame
The rear terminals for main circuit connection of the guide frame are delivered completely
mounted. They can be turned from the horizontal to the vertical orientation and vice verse if
necessary.
1. Remove the rear terminals for main circuit connection from the guide frame.
2. Turn the terminals into the required orientation and mount them back on the ange of the
guide frame.
Connection and commissioning
5.2Mounting and connecting the device
3VA27 molded case circuit breakers & 3WL10 air circuit breakers
Equipment Manual, 10/2023, L1V30499596002-03 161
To Next Page
Loading...
