Siemens Sentron 7KN POWERCENTER 1000 - Device Installation and Connection

Installation and connection
4.2 Device installation
Circuit protection devices with communication and metering function
26 System Manual, 06/2021, L1V30827018B-01
Note
In case of increased ambient temperatures, a correction factor must be applied for the rated
current. This applies to the 3NA
COM fuse at a temperature of > 40°C and the 5SV6 COM arc
fault detection device or the 5SL6
COM miniature circuit breaker at temperatures > 30°C
according to the respective configuration manual of the product family.
See also
Configuration Manual Miniature Circuit Breakers
(https://support.industry.siemens.com/cs/ww/en/view/45302792
)
Configuration Manual Residual Protective Devices /Arc Fault Detection Devices (AFDDs)
(https://support.industry.siemens.com/cs/ww/en/view/45303255
)
Configuration Manual Fuse Systems
(https://support.industry.siemens.com/cs/ww/en/view/45314810
)
4.2 Device installation
4.2.1 Install the 7KN POWERCENTER 1000
To install, simply snap the 7KN Powercenter 1000 data transceiver onto the DIN rail and snap
it into place.