Commissioning
5.4 Summary of 3NA COM fuses with the same name
Circuit protection devices with communication and metering function
System Manual, 06/2021, L1V30827018B-01
47
5.4 Summary of 3NA COM fuses with the same name
If several fuses are added, these are displayed together in the app. This is referred to as
"Device Group".
In order to summarize fuses in a device group, the plant identifier of the devices must match.
The respective installation position / phase should be specified for each fuse. As soon as the
plant identifier no longer matches, the devices are no longer displayed as a device group.
Note
A name can be given when adding the fuses. If this is not done, the default designation of
the devices remains. The unnamed devices are also summarized.
The representation in the app includes the number of grouped fuses (2 to max. 3 pieces), the
status (connected or not connected) and the indication of at least one present alarm.
5.5 Import and Export
Several devices can be added in the SENTRON powerconfig app and displayed in a project. If
it is necessary to summarize devices in different projects, it is recommended to export the
.splx file to the mobile device for each project after commissioning. Several projects can be
stored with different names in this manner and can be imported again at a later time.
During import, it must be ensured that the imported devices do not overwrite the existing
ones. If only the imported project is to be displayed, it is recommended to export the existing
project and then delete the devices. Alternatively, the different devices can also be
distinguished with a specific name.
Note
The PC version of SENTRON powerconfig must be used to get an overview of
different
projects or to move devices to different projects. The mobile app only supports a listing of all
added devices.
To Next Page
Loading...
