Siemens SENTRON PAC RS485 - Disassembly Instructions

Assembling
4.6 Disassembly
PAC RS485
Manual, 02/2008, A5E02091800B-01
27
4.6 Disassembly
Disassembling
1. Ensure safe isolation from supply.
2. Observe the ESD Guidelines. Discharge yourself. Handle the PAC RS485 expansion
module by the plastic housing only.
3. Remove the terminal block from the expansion module, or detach the cable from the
terminal block.
4. Unscrew the PAC RS485 expansion module from the SENTRON PAC Power Monitoring
Device.
5. Remove the PAC RS485 expansion module from the SENTRON PAC Power Monitoring
Device.
6. If necessary, disassemble the SENTRON PAC Power Monitoring Device.
More information
Disassembling the SENTRON PAC Power Monitoring Device
You can find information about how to disassemble the SENTRON PAC Power
Monitoring Device in the manual for the SENTRON PAC Power Monitoring Device.
See also
Electrostatic sensitive devices (ESD) (Page 81)